Lamontagne Kitchen Cabinets December 29th, 2017 - 12:52:45
If the kitchen cabinet hardware is not damaged it can be cleaned and re-installed. But, this is a great time to choose new cabinet hardware, doing so will let you really add your personality to the kitchen and complete the stunning transformation of your new look, refaced or refinished kitchen cabinets, on the cheap. The time required for refacing or refinishing kitchen cabinets depends on the size of the kitchen but usually can be completed within 3-5 days. This means that your kitchen will not be a unusable total wreck for weeks or even months that cabinet replacement requires. Buying all new cabinets for a complete remodeling of the kitchen is not in the budget of most homeowners. But as you can see up dating your kitchen need not break the bank or be time consuming. Your kitchen and home can have a stunning new look by simply refacing kitchen cabinets or refinishing kitchen cabinets.
If you are not interested in building kitchen cabinets you might be interested in purchasing pre-built or designer cabinets. One such designer cabinet you might be interested in are Merillat cabinets, which began in 1946. Today, Merillat is a leader in kitchen cabinets. Featuring three distinct designs to choose from, totaling over 50 patterns and styles, there is the Merillat Essentials, Merillat Classics and Merillat Masterpiece. Each having their own price ranges and distinctive designs to fit into any kitchen, Merillat is part of the American tradition of kitchen cabinets. Another type of kitchen cabinet that is a great alternative to building kitchen cabinets is the Kemper cabinet, which was founded in 1926 by brothers George E. and Paul W. and their friend, Ray L. Headington in Richmond, Indiana. In 1998, Kemper was purchased by MasterBrand, retaining the name Kemper, and is the second largest cabinet manufacturer in the United States. They offer a wide selection of cabinets, including oak kitchen cabinets, for everything from the bath to the kitchen to storage areas.
If the wall is flat, simply rip the filler board to the required width and fasten it in place. If the wall is irregular, youll have to scribe-fit the filler board. Start by setting a marking compass to the width of the gap, then place a strip of 1"-wide masking tape along the filler board in the area where it needs to be trimmed. Clamp the board to the end cabinets face frame, then trace the wall contour with the compass. Remove the board and cut along the scribe line with a jig saw, then reinstall it to check the fit. When its right, drive screws through the adjacent face frame into the edge of the filler board. Screw or nail the other side to the cleat.
9. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Then install and fasten the last cabinet and measure the gap between its face frame and the wall.